Bridge Commander Central

BC Forums => BC Modding => Topic started by: Starforce2 on February 18, 2008, 04:03:06 PM

Title: 2 sensor arrays on an hp
Post by: Starforce2 on February 18, 2008, 04:03:06 PM

Is there any secret to this? Or is it just to make sure the secondary is listed after the primary in the hp so the primary is active first?

Title: Re: 2 sensor arrays on an hp
Post by: MLeo on February 18, 2008, 04:14:10 PM

Only have 1 set as primary.

In other words: If you have 2 or more "top level" systems (Sensors/Engines/Shields/) then only 1 may be primary.


Maybe a hper could prove me right or wrong?

Title: Re: 2 sensor arrays on an hp
Post by: Starforce2 on February 18, 2008, 04:40:21 PM

next question, since only one is used at a time, does only one draw from the power systems at a time?

Title: Re: 2 sensor arrays on an hp
Post by: MLeo on February 18, 2008, 05:36:03 PM

Try it. :P
Set the Warpcore to produce 50, set the primary to use 10, set the secondary to use 40 and every other system to use 0.

But, again, you will have to ask a hper.

Title: Re: 2 sensor arrays on an hp
Post by: Adonis on February 21, 2008, 02:03:30 PM

Look at my Oberth's HP. That setup works like a charm.

Title: Re: 2 sensor arrays on an hp
Post by: El on February 21, 2008, 03:10:07 PM

As far as I know they both draw power.

However you have to be careful to set the sensor ranges to be the same, otherwise you get what I call 'flick' where targets appear and disappear from sensors rather annoyingly.