Bridge Commander Central

BC Forums => BC General => Topic started by: serverandenforcer on December 30, 2009, 09:15:34 PM

Title: Hello Again
Post by: serverandenforcer on December 30, 2009, 09:15:34 PM

Ok, so I've been away from this community for quite some time again.  What happened is that 1.) I transfered from reservist to active duty this past March, 2.) moved into a new place and hadn't setup internet there untill recently, 3.) lost my BC disk, thought it was permanently gone until I found it a few days ago, and because I thought it was permanently gone, I had deleted all of my BC installs from my computer.  So up untill I had found the disk, I saw no point for me to be very involved in the community.  Now that I've found it... I'm baaacckkkk!!!!!!!.... again.

So, I just re-installed BC and patched it up.  Which order would be the correct way for me to install the following mods?.....

SCRIPTS
abandonship0.5.1
core power to battery and backup1_2
cws_2.0
diamondbc_redistribute shields
distress0.4
mvam infinite
orbit target1.0
overload_systems
powe rcurrent
power transfer
diamondBC_projectiles
redistribute_shields v1
repair_destroyed_systems_beta_edition
shield output
sneaker core eject
tech freamework 1.2
vent plasma
galaxy charst v2
gravity fx
inaccurate phasers
kmupdate 0.9.1
ds9fx_v3.0 (wasn't there nanofx beta issue with this?)

FX
cinematic explosions
FluxCapacitor's Realistic Damage Textures v1.1
nanofx 2.0 beta w/nanofx 2 beta fix
plasma rupture textures
shield pack by FourChan
slipstream framework



So now that I'm back, this means that I will be returning to work on some of my projecgts that I had left unfinished.  However, I am in the military, so my time to work on them may not be consistent.  Anyways, hope everybody is enjoying the holidays.

Title: Re: Hello Again
Post by: ACES_HIGH on December 30, 2009, 11:10:52 PM

the easiest thing to do would be to install KM1.1 Beta, which includes most of those mods.

Title: Re: Hello Again
Post by: JimmyB76 on December 30, 2009, 11:21:09 PM

Aces is correct - your best bet would be to start there, and then build from that...

Title: Re: Hello Again
Post by: serverandenforcer on December 31, 2009, 01:02:42 AM

Cool deal.  Thanks guys!

Title: Re: Hello Again
Post by: serverandenforcer on December 31, 2009, 02:10:05 AM

Hm, for some odd reason I'm getting the black screen with the cursor arrow after installing KM

Title: Re: Hello Again
Post by: JimmyB76 on December 31, 2009, 07:44:09 AM

what was your installation process?  because as far as KM goes, it should go like this:
clean fresh BC install (only) ---> BC 1.1 patch ---> KM beta

also, as far as the BSOD, can you provide a console report which would show which script is causing the error?  there is a stickied thread in the Tech Support forum that explains about how to obtain a console report...