nvm i downloaded it...
to have your new retexture of the ST5 Ent-A bridge show up named DIFFERENTLY than "ST5EntA" in your bridge menu:
in scripts/Custom/Autoload open ST5_Ent-Abridge script (make a backup first of course!)
look for:
Foundation.BridgeDef('ST5EntA', 'ST5_Ent-Abridge', dict = {
change 'ST5EntA' to whatever bridge name you would like...
delete ST5_Ent-Abridge pyc
your new bridge name should replace "ST5EntA" in your bridge menu...
if you want BOTH the ST5 Ent-A AND the name your new retextured bridge listed in your bridge menu, that can be done also but it takes a few more steps and a bit more in depth...
first, go to data/Models/Sets
make a copy of ST5_Ent-ABridge folder and rename it to whatever you want...
second, go to scripts/Bridge and make a copy of ST5_Ent-Abridge script and rename that script to match the name of your retextured data/Models/Sets folder...
third, open the new script you just copied and renamed and look for the following:
def CreateBridgeModel(pBridgeSet):
iDetail = App.g_kImageManager.GetImageDetail()
pcDetail = [ "Low/", "Medium/", "High/" ]
pcEnvPath = "data/Models/Sets/XXXXXXXXXX/" + pcDetail[iDetail]
# Pre-load the Bridge model and viewscreen
App.g_kModelManager.LoadModel("data/Models/Sets/XXXXXXXXXX/EnterpriseAbridge.nif", None, pcEnvPath)
App.g_kModelManager.LoadModel("data/Models/Sets/XXXXXXXXXX/EnterpriseAViewScreen.NIF", None, pcEnvPath)
# Load the viewscreen and set it up specially with SetViewScreen()
pViewScreen = App.ViewScreenObject_Create("data/Models/Sets/XXXXXXXXXX/EnterpriseAViewScreen.NIF")
pBridgeSet.SetViewScreen(pViewScreen, "viewscreen")
# Setup bridge object
pBridgeObject = App.BridgeObjectClass_Create("data/Models/Sets/XXXXXXXXXX/EnterpriseAbridge.nif")
pBridgeSet.AddObjectToSet(pBridgeObject, "bridge")
pBridgeObject.SetTranslateXYZ(0.000000, 0.000000, 0.000000)
pBridgeObject.SetAngleAxisRotation(0.000000, 1.000000, 0.000000, 0.000000)
that section in the bridge script points to the folder in data/Models/Sets
where XXXXXXXXXX is the exact name of the new folder you just created with your new retextured bridge in data/Models/Sets - and it is case sensitive!
fourth, go to scripts/Custom/Autoload and make a copy of ST5_Ent-Abridge script (and a backup!)
rename that new copied script to your new retextured bridge name...
look for:
Foundation.BridgeDef('ST5EntA', 'ST5_Ent-Abridge', dict = {
change 'ST5EntA' to whatever bridge name you would like...
you should then have both the ST5 Ent-A bridge as well as the name of your retextured bridge listed in your bridge menu...
please post here if it all worked or not...
it has been a while since ive done this all myself, so i am going on memory here lol